So my printing setup is a little weird, my cooling fan header is swapped with the parts cooling fan. I am too lazy to swap them out so I decided to swap them in software the best I could within my Slic3r settings below. This GCode may or may not work for you, use at your own risk.
Continue reading “Custom GCode for Slic3r and Octoprint”Marlin 1.1.19 on Kossel Mini with ZProbe
I got into 3D Printing about two years ago, my first printer was an wanhao i3 with a 200mm x 200mm x 180mm bed. It served me well for about a year and then I wanted more. In comes the Kossel Mini, with a 175mm x 175mm x 300mm bed size. So much room for vertical printing activities!
This post is going to be about my on-going project to setup my 3D Printing enclosure that I have built over the last year. This project is far from done however, I would like to share my setup at this point to hopefully give someone an idea of the Kossel Mini setup.
Continue reading “Marlin 1.1.19 on Kossel Mini with ZProbe”